FAQs Frequently Asked Questions About our Products and Solutions

All FAQs (363 total: showing 201-220)

Does CRBasic have to be used to program a data logger? Does a menu-driven program generator exist for the data logger?
What is the overall length of the CR1000 (including screw tabs) when the CFM100 or NL115 module is added to the wiring panel/interface of the CR1000?
How can I use a datalogger to measure solar radiation?
Can just the plastic, three-prong cup part of the 03001-L be replaced on a weather station?
What is the conversion for evapotranspiration using wheat instead of turf grass? Also, is there anything for bare soil?
What is the 229 heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
I have an old CR10 datalogger that has not been used in years. The problem I am having is as soon as the power is shut off, all the data and programs are lost. Is there anyway to prevent this?
What is the optimum calibration frequency for a WindSonic?
Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
Where is the interface cable for the WindSonic?
Do you have 1-D anemometer having 4 Hz or higher frequency to measure the vertical wind velocity?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart data logger to give wind speed and direction on a non-fixed platform?
What is the reliability rating of the WindSonic?
Can the CR5000 store data with a rate of 1000 Hz?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?
Can the CR1000 provide alarms?

Previous Next